By Derrick Henderson, President of Lifestyle Design Homes and a Florida Certified Building Contractor with more than 20 years in construction. Updated November 2026.
In Southwest Florida the flood zone decides how high a new home sits, what sits under it, how much fill the lot needs, and what the flood insurance costs. The statewide rule is the same everywhere: in a mapped flood zone, the lowest floor goes at least one foot above the base flood elevation. What changes from one city to the next is who reviews it and what each one adds on top.
This guide puts the eight places we build side by side, explains the flood map changes coming to both counties in 2027, and covers what a buyer should check before choosing a lot. The zones themselves, from VE to X, are explained in our guide to designing for the Southwest Florida climate.
Key takeaways
- One statewide minimum: in a mapped flood zone, the lowest floor sits at least 1 foot above the base flood elevation.
- Local rules add to it: unincorporated Collier County also puts the floor at least 18 inches above the crown of a paved road, and Estero applies a road rule in zone X.
- Both counties get new flood maps in 2027: Lee County’s take effect on March 2, and Collier County is targeting summer.
- An elevation certificate is done twice: during construction and at completion, by a licensed surveyor.
- Federal flood insurance stops at $250,000 for the building: a larger home needs private or excess coverage to be insured for what it would cost to rebuild.
In this guide
- How to find the flood zone
- Floor height, city by city
- How the floor height is set for a lot
- The new flood maps in 2027
- The elevation certificate
- What elevation does to the budget
- Flood insurance above $1 million
- A lot with an old house on it
- What the seller has to tell you
- How we handle flood requirements
- Frequently asked questions
How do you find the flood zone for a lot?
From FEMA’s Flood Insurance Rate Map. Enter the address on the FEMA Flood Map Service Center, or use the county tools: Collier County’s flood map and Lee County’s flood pages. Four things matter on the result: the zone, the base flood elevation, the map panel number, and the date the map took effect.
A listing that says “zone X” is a start, not an answer. The zone line can run through a lot, and the base flood elevation means little until it is compared with the height of the ground and the road. That comparison needs a survey with elevations, and it is one of the fourteen checks in our guide to building on your own lot.
How high does the floor have to be, city by city?
The Florida Building Code sets the floor for everyone: in a mapped flood zone such as AE, the lowest floor sits at least one foot above the base flood elevation, or at the design flood elevation if that is higher. Every city and county we work in uses that minimum. The differences are in who runs the review and the rules each one adds.
| Where the lot is | Who runs the flood review | Lowest floor in a mapped flood zone | What else to know | NFIP discount (CRS class) |
|---|---|---|---|---|
| Collier County, outside the cities | Collier County | BFE + 1 ft | The floor also sits at least 18 inches above the crown of a paved road, or 24 inches above an unpaved one. | Class 5, up to 25% |
| City of Naples | City of Naples | BFE + 1 ft | Inside the city limits, the City’s floodplain rules apply, not the county’s. | Class 5, up to 25% |
| Marco Island | City of Marco Island | BFE + 1 ft | An elevation certificate goes in with the permit application, and the 35-foot height limit is measured from the required flood elevation. | Class 5, up to 25% |
| Bonita Springs | City of Bonita Springs | BFE + 1 ft | Near the Gulf, in Coastal A and VE zones, the City adds limits on enclosures, slabs and decks. | Class 5, up to 25% |
| Estero | Village of Estero | BFE + 1 ft | In zone X, the floor sits at least 1 foot above the crown of the road. | Class 6, up to 20% |
| Fort Myers, inside the city | City of Fort Myers | BFE + 1 ft | Mechanical, plumbing and electrical systems go at the same height as the floor. | Class 6, up to 20% |
| Cape Coral | City of Cape Coral | BFE + 1 ft | On a canal, the home cannot be occupied until the seawall is installed and inspected. | Class 5, up to 25% |
| Lee County, outside the cities, including Lehigh Acres | Lee County | BFE + 1 ft | A fill and drainage plan is required when the finished grade sits more than 18 inches above the road. | Class 5, up to 25% |
BFE is the base flood elevation shown on the FEMA map for the parcel. The discount comes from FEMA’s Community Rating System and applies to National Flood Insurance Program policies, in full inside the high-risk zones and at a lower rate outside them. Sources: Florida Building Code, Residential, Section R322; Collier County Floodplain Management; Lee County Floodplain Management; FEMA’s list of Community Rating System communities effective October 1, 2026; Village of Estero; City of Fort Myers Ordinance 4006; City of Marco Island; City of Cape Coral. Checked November 2026. The number for a specific lot is always confirmed with the city or county.
How is the floor height set for a specific lot?
There is no single number we add to every home. We set the finished floor project by project, from the flood requirements that apply to the parcel, the local regulations, the survey and the engineer’s recommendations. Before the height is fixed, we check the required base flood elevation and any freeboard, the extra height a jurisdiction asks for above it. The right answer changes with the city or county, the flood zone and the conditions on the lot.

The drawing shows how two rules meet on a lot in unincorporated Collier County. The floor has to clear both the flood limit and the road limit, so the higher of the two decides. On an inland lot where the base flood elevation is low, that can be the road.
Are the flood maps about to change?
Yes, in both counties. In Lee County, FEMA issued its final determination in September 2026, and the revised maps take effect on March 2, 2027. In unincorporated Lee County the change is limited to six map panels, and the county plans to send letters in January 2027 to the owners of parcels moving into the Special Flood Hazard Area. The county’s page on the 2027 revisions lists the panels and shows how to check a parcel.
Collier County is a step behind. FEMA released preliminary maps on March 20, 2025, the 90-day appeal period opened on August 19, 2026, and the county’s target for the new maps to take effect is summer 2027. The preliminary maps are on FEMA’s Flood Map Changes Viewer.
A new map can move a lot into a different zone or change its base flood elevation. That changes the flood insurance, and for a home that has not been permitted yet, it can change the height the home has to be built to.
Flood zones are part of our first conversations with buyers, especially when they are looking at vacant land in Collier or Lee County. We encourage every buyer to check the current effective flood zone for the property and any proposed map change, to understand the elevation and construction requirements that come with it, and to consider what flood exposure does to the design, the insurance and the long-term cost of owning the home. The flood zone is one factor in whether a lot suits the home, not the only one.
What is an elevation certificate, and when is it done?
It is a FEMA form, prepared by a licensed surveyor, that records how high the finished home sits compared with the base flood elevation. On a new home in a flood zone it is done twice: once during construction, at the lowest floor stage, and once when the home is finished. Lee County requires both. On Marco Island one goes in with the permit application.
The certificate matters after the build too. The insurer uses it to rate the flood policy, and a future buyer will ask for it. It belongs in the file with the survey and the permit documents.
On our projects, the certificate is prepared by a licensed professional, typically the surveyor, and our team coordinates the survey and elevation documents as part of permitting and construction.
What does elevation do to the budget and the design?
The required height is a site cost before it is a design detail. On a low inland lot it usually means fill brought in to raise the building pad, then grading so the water drains away from the home and the neighbors. The foundation follows from the same number, and there is no single system for every lot. Depending on the soil, the required elevation and the engineering, a home may sit on a stem wall, on an engineered elevated foundation or on piles. In coastal VE zones the code calls for an open foundation of piles or columns, and the space below can only be used for parking, access and storage.
The height also shapes the house: the driveway slope, the steps at the front door, the garage, and the transition to the pool deck. In unincorporated Collier County, the road rule can set the floor higher than the flood map does on an inland lot. That is why two lots at the same price can carry very different site costs, as our guides to site preparation and planning a custom home budget explain.
How does flood insurance work for a home above $1 million?
A mortgage from a federally regulated lender on a home in a high-risk zone comes with a flood insurance requirement. Outside those zones it is optional under federal rules, although a lender can still ask for it. For a home in this price range, two numbers matter.
The first is the limit of the National Flood Insurance Program: $250,000 for the building. A larger home needs private flood coverage, or an excess policy on top of the federal one, to be insured for what it would cost to rebuild. The second is Citizens Property Insurance, the state-backed insurer. In most of the state, a home with a dwelling replacement cost of $700,000 or more is not eligible for it, and by January 1, 2027, Citizens will require flood coverage on most of its home policies that include wind coverage.
The height of the first floor is one of the factors in a flood premium, so it is worth asking an insurance agent for a quote while the design is still open, not after the slab is poured. The discounts in the table above apply to federal policies. We do not quote premiums, because they depend on the policy and the home.
Wind is a separate policy with separate rules, and Ian showed how far flooding can reach beyond the mapped high-risk zones. The structural side of storm protection is covered in our climate guide.
What if the lot already has a house on it?
Then the 50 percent rule comes into play. If the cost of improving or repairing an existing home in a flood zone reaches half of the structure’s market value, the whole building has to be brought up to current flood standards, including the elevation. For an older, low home that can mean raising it or rebuilding it.
Since June 2025, Florida law no longer allows local governments to add improvements together over several years when they apply the rule. Each permit is measured on its own. On many lots with an older house, as on the north end of Marco Island, the cleaner path is a new home on a new foundation, built at the height the code requires today.
What does the seller have to tell you about flooding?
Since October 1, 2024, the seller of a residential property in Florida has to give the buyer a flood disclosure at or before the signing of the contract. It states whether the seller knows of flooding that damaged the property during their ownership, whether they filed a flood insurance claim, including with the National Flood Insurance Program, and whether they received federal flood assistance, such as from FEMA.
The form covers the seller’s history, not the flood zone or the required elevation. Those still come from the map, the survey and the city or county, before you commit to the lot.
How do we handle flood requirements?
We look at the flood zone before we talk about the house. For buyers who have not bought the land yet, we can do a preliminary homesite evaluation: access, the apparent site conditions, the surrounding development, what the property may ask of the construction, and the home you have in mind. A site visit does not replace a survey, an engineering assessment or a formal feasibility study, so we coordinate those when the property calls for them. The evaluation works for buyers who live elsewhere too, as our guide to building a home from out of state explains.
Once the lot is chosen, the required elevation drives the fill, the foundation, the drainage and the site-work line of the budget. Our team has built 10 waterfront homes across Southwest Florida, most of them on canals in Naples and the communities around it, where the flood elevation, the seawall and the setbacks are planned together.
Frequently asked questions
How high does a new home have to be built in a flood zone in Florida?
In a mapped flood zone such as AE, the Florida Building Code requires the lowest floor to sit at least 1 foot above the base flood elevation, or at the design flood elevation if that is higher. In coastal VE zones the measurement is taken at the bottom of the lowest horizontal structural member. Local rules can be stricter, never looser, so the city or county confirms the number for each lot.
How high above the road does a new house have to be in Collier County?
In unincorporated Collier County, the lowest living floor of a new home has to sit at least 18 inches above the crown of the road if the road is paved, or 24 inches if it is unpaved. That rule comes from the county’s floodplain management ordinance and applies on top of the base flood elevation plus 1 foot.
When do Lee County’s new flood maps take effect?
On March 2, 2027. In unincorporated Lee County the revision is limited to six map panels. FEMA issued its final determination in September 2026, and the county plans to notify the owners of parcels moving into the Special Flood Hazard Area in January 2027.
Is Collier County getting new flood maps?
Yes. FEMA released preliminary maps for Collier County on March 20, 2025, the 90-day appeal period began on August 19, 2026, and the county’s target for the new maps to take effect is summer 2027. The preliminary maps can be viewed on FEMA’s Flood Map Changes Viewer.
Do I need flood insurance in zone X?
There is no federal requirement to carry flood insurance in zone X, although a lender can still ask for it. Citizens Property Insurance will require flood coverage on most of its home policies that include wind coverage by January 1, 2027, wherever the home is.
Does Florida’s 50 percent rule add up improvements over several years?
No longer. Since June 2025, Florida law bars local governments in the National Flood Insurance Program from adopting or enforcing a cumulative substantial improvement period. Each permit is measured against the 50 percent threshold on its own.
Who prepares an elevation certificate?
A Florida licensed surveyor prepares it on FEMA’s form. On a new home it is done during construction, at the lowest floor stage, and again when the home is finished. It confirms the home meets the required elevation and is used to rate the flood insurance.
Before you start
Look up the flood zone and the base flood elevation for the address, and check the pending map in both counties. Get the survey and find the height of the road. Ask the seller for the flood disclosure and any elevation certificate on an existing house. Then get a flood insurance quote while the design is still open. If you are still comparing builders, ask each one how they would set the floor height for this lot. Our guide to choosing a custom home builder in Southwest Florida covers the other questions to ask.
Looking at a lot in a flood zone? Contact Lifestyle Design Homes in Estero. We will read the map for the parcel before you commit.
Start a conversation